Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 22, No. 4 (1998)

Sandy Jackson

Individual tip 1 of 2 from this reader’s published contribution.
Sandy Jackson, Etowah, Tenn.

“I had a problem with my New Idea 456 round baler breaking bearings and shafts on the main roller at the bottom. The problem was that the 1 to 1 1/2-in. shaft on the right side (from rear) wasn’t long enough. The sheet metal would flex under load and allow the bearing (or bearing shaft) to move to the left out of the bearing holder. I broke 2 or 3 shafts and bearings.

“I solved the problem by making the shaft 4 to 5 in. longer and adding an extra bearing. I installed a plate on the outside of the baler, then transferred the bolt pattern for the bearing holder to the plate and countersunk the bolt heads. Then I added a flange bearing with a bearing lock and set screw. The lock keeps the shaft from moving from side to side while the plate makes the assembly more rigid. Since the shaft was made longer, the sheet metal on the side of the baler had to be slotted vertically, the same as on the other (drive) side. This makes it easy to install with a floor jack.

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.