“I also built a tire bead-seating tool similar to some commercial models available, but for a fraction of the cost.
“I used a 5-gal. air tank I bought on sale for $19. I drilled a hole in the side of the tank and welded in a 3-in. length of 1 in. dia. pipe. I fitted it with a plastic ball valve and ran a 6 in. length of 1 in. dia. pipe out from it. I fitted it with a 6 in. length of exhaust pipe I’d hammered flat on one end. I made a stop to hold the piece of tail pipe against the rim as close to the tire as possible.
“To use you simply inflate the tank with about 70 lbs. of air, insert the flattened tail pipe between the tire and rim and open the ball valve. The tire will expand and finish seating the bead as the air rushes in.
“Cost only about $50 to build, compared with some commercial bead seaters that run up to $300.
“One caution: It’s essential to do a good welding job or the pipe or pipes could fly off and injure someone when this tool is used.”
Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.
Comments and votes
Have you tried this idea? Mark it helpful and share how it worked in your shop.