Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 21, No. 6 (1997)

Marvin Heins

Marvin Heins, Houston, Ohio

Source context: Printed page 31 is PDF page 30: the scanned printed22–23 spread occupies one PDF page in this issue.

“After years of constantly replacing worn-out rubber bushings on my New Holland Haybine’s sickle head, I solved the problem by replacing the bushing with a ball bearing.

“It’s a simple solution but it solved the problem. The New Holland Haybine is a good machine overall but it has a troublesome sickle drive system. Our machine is 12 years old, but newer models have the same problem. We were never able to cut more than 100 acres before the bushing wore out and we had to replace it. Once we were able to cut only 5 acres before the bushing wore out.

“The bushing mounts inside a steel ring welded to one end of the sickle. The sickle drive arm uses a bolt to drive the bushing. The problem is that the arm has too much movement which causes the bushing to wear out prematurely.

“I replaced the bushing with a 1/2-in. dia. bore bearing equipped with an extended inner race on both ends. I cut off the ring where it joins the back of the sickle and welded on a new ring, using the ring’s original insert that goes into the flange head assembly but discarding the locking collar. After the weld had cooled I pressed the bushing out, then drilled three holes in the ring to match those in the bearing flange. I inserted three 5/16-in. dia. cap screws through the holes, put the washers on, and applied Lock Tite thread locking compound to secure the bearing. I then bolted the ring to the arm.

“I used a regreasable bearing because I happened to have it on hand. However, I see no reason why a conventional sealed bearing wouldn’t work. We replaced the bushing three years ago and have cut more than 600 acres since then without an ounce of trouble.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.