Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 21, No. 4 (1997)

Jack L. Docken

Jack L. Docken, Winner, S. Dak.

Jack built a stand to sharpen the 9-ft. sickles on his International mower.

“I used an 8-ft. length of 1 in. angle iron. I welded a pair of 3/8-in. hex nuts to it every 24 in. to hold the sickle in place. The angle iron welds across the top of an old wool sack holder that’s about 30 in. high. Angled braces support each end of the sickle holder.

“To use, you simply set the sickle in the angle iron and sharpen with a #60 or #80 sanding disk with your sander running on low rpm’s.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.