Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 21, No. 2 (1997)

Gary Crawford

Gary Crawford, Lyons, Kan.

“I discovered a slick, quick way to realign the feeder chains on my 1981 Gleaner N6 combine. On this combine and many others, three feeder chains run around the drive sprockets. As sprockets and chains wear, the outer chain has a tendency to jump a tooth, especially in heavy crops. My dealer used to tell me to loosen all the chains so I could readjust the slipped one. I streamlined the process by using a pipe wrench to rotate the drive shaft that runs to the header and laying a 5/8 or 3/4-in. dia. brightly colored 1-ft. length of pipe at the pinch point between the chain and sprocket. As one man rotates the driveshaft and another holds the pipe, the feeder chain will jump the tooth and snaps back into place. Whether you rotate the shaft clockwise or counterclockwise depends on which way the chain jumped the tooth in the first place. This will work on front or back feeder chains as well as conveyor chains.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.